Connected wearables
Withings Go battery
1 × 3V lithium coin cell
How to replace it
| How to open | Turn over; place provided tool (or coin) in back-case groove; turn counterclockwise until marking aligns with the dot |
|---|---|
| Orientation | Replace CR2032 in compartment (observe polarity as fitted) |
| Seal / O-ring | O-ring must stay in place — it provides waterproofing |
| Water resistance | Reseat and lock cover clockwise with tool after battery change |
| Notes | Be careful not to damage the groove if using a coin. |
| Access | Tool-free |
| Gasket / O-ring present | Yes |
Sources
Helpful for this device
Optional tools for opening, testing or charging — separate from the battery answer.
- Fluke 101 Digital Multimeter
Accurate open-circuit voltage and basic electrical checks
- Klein Tools MM400 Multimeter
General DC voltage checks including battery terminals
- Digital multimeter
Measure open-circuit voltage and general electronics checks
New battery but still not working?
A fresh 1 × CR2032 should restore Withings Go if the battery was the problem. Work through the checks below before replacing the device.
- Check orientation
Confirm the cell is seated correctly: Replace CR2032 in compartment (observe polarity as fitted)
- Check the battery type
This device needs 1 × CR2032 (lithium). Rechargeable cells are not supported for this device. Same size does not always mean the same battery.
- Check known model-specific issues
O-ring must stay in place — it provides waterproofing
- Confirm the battery itself
For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.
- Still not responding?
If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.