Garmin · Connected wearables

Garmin vívofit 3 battery

1 × 3V lithium coin cell

Garmin vívofit 3 / vivofit 3 takes one CR1632 lithium coin cell. Remove the device from the band, undo the four back screws, replace the cell, and align the arrows when refitting the band.

Based on
Garmin documentation
Last checked
7 October 2026
Size
16 × 3.2 mm
Voltage
3 V
Rechargeable
Not supported

How to replace it

How to openRemove device from band; remove four Phillips screws on back; remove rear case and battery
ToolsSmall Phillips screwdriver
OrientationNegative side facing the inside of the front cover
Seal / O-ringVerify gasket is not damaged and fully seated in the rear case
NotesAlign arrow on device with arrow inside band when reinserting.
AccessSimple screwdriver
Gasket / O-ring presentYes

Sources

Need a CR1632?

Garmin vívofit 3 uses 1 × CR1632.

Buy links go to Amazon (Associates where tagged) or other affiliate programmes when available. They never change the battery answer.

Helpful for this device

Optional tools for opening, testing or charging — separate from the battery answer.

Amazon links may earn us a commission. They do not change the battery answer.

  • Digital multimeter

    Measure open-circuit voltage and general electronics checks

    Voltage alone does not establish usable capacity, especially for rechargeables.

Buy links are optional and separate from the battery answer.

New battery but still not working?

A fresh 1 × CR1632 should restore Garmin vívofit 3 if the battery was the problem. Work through the checks below before replacing the device.

  1. Check orientation

    Confirm the cell is seated correctly: Negative side facing the inside of the front cover

  2. Check the battery type

    This device needs 1 × CR1632 (lithium). Rechargeable cells are not supported for this device. Same size does not always mean the same battery.

  3. Check known model-specific issues

    Verify gasket is not damaged and fully seated in the rear case

  4. Confirm the battery itself

    For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.

  5. Still not responding?

    If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.

These checks follow this device’s orientation, battery type, and important notes from the maker.

Current model

If this model is finished, the Manufacturer successor model is Garmin vívofit 4.

Buy links go to Amazon (Associates where tagged) or other affiliate programmes when available. They never change the battery answer.

Related models

Other devices using CR1632

See all →

See all 7 devices using CR1632 →

Related models

Similar devices