Aqara · Smart home sensors
Aqara Door and Window Sensor battery
1 × 3V lithium coin cell
How to replace it
| How to open | Open battery compartment on sensor body; replace CR1632. Reseat cover. |
|---|---|
| Notes | Original Zigbee model MCCGQ11LM — not P1 (CR123A). |
| Access | Tool-free |
Important
- Generation: original Door and Window Sensor (MCCGQ11LM) is 1× CR1632 — P1 (MCCGQ13LM) is 1× CR123A.
Sources
Helpful for this device
Optional tools for opening, testing or charging — separate from the battery answer.
- Coin cell / button cell battery tester
Quick check of CR / LR / SR button and coin cells before fitting
- Fluke 101 Digital Multimeter
Accurate open-circuit voltage and basic electrical checks
- Digital multimeter
Measure open-circuit voltage and general electronics checks
New battery but still not working?
A fresh 1 × CR1632 should restore Aqara Door and Window Sensor if the battery was the problem. Work through the checks below before replacing the device.
- Check the battery type
This device needs 1 × CR1632 (lithium). Rechargeable cells are not supported for this device. Same size does not always mean the same battery.
- Check known model-specific issues
Generation: original Door and Window Sensor (MCCGQ11LM) is 1× CR1632 — P1 (MCCGQ13LM) is 1× CR123A.
- Confirm the battery itself
For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.
- Still not responding?
If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.
Current model
If this model is finished, the Latest generation model is Aqara Door and Window Sensor P1.