Samsung · Trackers

Samsung Galaxy SmartTag2 battery

1 × 3V lithium coin cell

Based on
Samsung documentation
Last checked
7 October 2026
Size
20 × 3.2 mm
Voltage
3 V
Rechargeable
Not supported

How to replace it

CompartmentRear battery tray
How to openInsert ejection pin (or small clip) into rear battery-tray hole; gently pull tray out; replace battery; reinsert tray securely
OrientationPositive (+) terminal aligned with + symbol; positive facing up
ToolsEjection pin or small clip
NotesIf SmartTag2 sounds immediately after insertion, battery may not be recognized — remove and reinsert with correct alignment. Do not insert tray upside down.
AccessSimple screwdriver

Important

  • Do not recharge CR2032
  • Incorrect tray orientation can damage device
  • Do not recharge CR2032.
  • Incorrect tray orientation can damage the device.

Sources

Need a CR2032?

Samsung Galaxy SmartTag2 uses 1 × CR2032.

Buy links go to Amazon (Associates where tagged) or other affiliate programmes when available. They never change the battery answer.

Helpful for this device

Optional tools for opening, testing or charging — separate from the battery answer.

Amazon links may earn us a commission. They do not change the battery answer.

  • Digital multimeter

    Measure open-circuit voltage and general electronics checks

    Voltage alone does not establish usable capacity, especially for rechargeables.

Buy links are optional and separate from the battery answer.

New battery but still not working?

A fresh 1 × CR2032 should restore Samsung Galaxy SmartTag2 if the battery was the problem. Work through the checks below before replacing the device.

  1. Check orientation

    Confirm the cell is seated correctly: Positive (+) terminal aligned with + symbol; positive facing up

  2. Check the battery type

    This device needs 1 × CR2032 (lithium). Rechargeable cells are not supported for this device. Same size does not always mean the same battery.

  3. Check known model-specific issues

    Do not recharge CR2032 Incorrect tray orientation can damage device Do not recharge CR2032.

  4. Confirm the battery itself

    For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.

  5. Still not responding?

    If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.

These checks follow this device’s orientation, battery type, and important notes from the maker.

Other devices using CR2032

See all →

See all 49 devices using CR2032 →

Related models

Similar devices