Samsung · Trackers
Samsung Galaxy SmartTag+ battery
1 × 3V lithium coin cell
How to replace it
| Compartment | Same family as SmartTag (confirm SKU packaging) |
|---|---|
| Orientation | Positive (+) aligned with + symbol |
| How to open | Use ejection pin / clip in rear tray hole to remove battery tray; replace CR2032; reinsert tray |
| Tools | Ejection pin or small clip |
| Access | Simple screwdriver |
Important
- Samsung SmartTag family guides state CR2032; confirm against specific SmartTag+ manual if available
- Do not recharge CR2032.
Sources
Helpful for this device
Optional tools for opening, testing or charging — separate from the battery answer.
- iFixit Essential Electronics Toolkit
Opening compartments that need precision bits
- Fluke 101 Digital Multimeter
Accurate open-circuit voltage and basic electrical checks
- Digital multimeter
Measure open-circuit voltage and general electronics checks
New battery but still not working?
A fresh 1 × CR2032 should restore Samsung Galaxy SmartTag+ if the battery was the problem. Work through the checks below before replacing the device.
- Check orientation
Confirm the cell is seated correctly: Positive (+) aligned with + symbol
- Check the battery type
This device needs 1 × CR2032 (lithium). Rechargeable cells are not supported for this device. Same size does not always mean the same battery.
- Check known model-specific issues
Samsung SmartTag family guides state CR2032; confirm against specific SmartTag+ manual if available Do not recharge CR2032.
- Confirm the battery itself
For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.
- Still not responding?
If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.
Current model
If this model is finished, the Manufacturer successor model is Samsung Galaxy SmartTag2.