Film cameras

Pentax ME Super battery

2 × 1.5V alkaline button cell

The Pentax ME Super takes two LR44 alkaline or SR44 / G13 silver-oxide cells for the electronics. This is not a PX625 mercury meter cell (a common Spotmatic-era confusion). Strong UK search interest; same dual button-cell pattern as many late-1970s electronic SLRs.

Based on
Pentax documentation
Last checked
8 October 2026
Size
11.6 × 5.4 mm
Voltage
1.5 V
Battery powers
Shutter & electronics — Powers electronic exposure systems in AUTO and M modes
Works without battery
Yes — Manual notes emergency operation without batteries is limited — prefer live cells for normal use
Replacement notes
Multiple cell options · Chemistry-sensitive
Rechargeable
Not supported

Other batteries in this device

How to replace it

CompartmentBattery chamber in the camera base
How to openOpen the battery chamber cover with a coin; insert two LR44/SR44 cells with the polarity shown (often + facing down).
OrientationFollow diagram in the chamber / manual
Low battery indicatorViewfinder LEDs flicker when batteries are low; fail to light when dead
NotesReplace both cells together. Not a PX625 mercury meter cell.
AccessCoin or simple twist

Important

  • Takes two LR44 alkaline or SR44 / G13 silver-oxide cells — not a PX625 mercury cell (common confusion with Spotmatic-era Pentax).
  • UK search interest is strong for this model; same dual button-cell pattern as many late-1970s electronics SLRs.
  • One CR13N is sometimes used as a substitute; the manual centres on two 1.5V cells.
  • Keep button cells away from children.

Sources

Need a LR44?

Pentax ME Super uses 2 × LR44.

Buy links go to Amazon (Associates where tagged) or other affiliate programmes when available. They never change the battery answer.

Helpful for this device

Optional tools for opening, testing or charging — separate from the battery answer.

Amazon links may earn us a commission. They do not change the battery answer.

  • Digital multimeter

    Measure open-circuit voltage and general electronics checks

    Voltage alone does not establish usable capacity, especially for rechargeables.

Buy links are optional and separate from the battery answer.

New battery but still not working?

A fresh 2 × LR44 should restore Pentax ME Super if the battery was the problem. Work through the checks below before replacing the device.

  1. Check orientation

    Confirm the cell is seated correctly: Follow diagram in the chamber / manual

  2. Check the battery type

    This device needs 2 × LR44 (alkaline). Rechargeable cells are not supported for this device. Same size does not always mean the same battery.

  3. Check known model-specific issues

    Takes two LR44 alkaline or SR44 / G13 silver-oxide cells — not a PX625 mercury cell (common confusion with Spotmatic-era Pentax). UK search interest is strong for this model; same dual button-cell pattern as many late-1970s electronics SLRs. One CR13N is sometimes used as a substitute; the manual centres on two 1.5V cells.

  4. Confirm the battery itself

    For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.

  5. Still not responding?

    If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.

These checks follow this device’s orientation, battery type, and important notes from the maker.

Other devices using LR44

See all →

See all 32 devices using LR44 →

Related models

Similar devices