Styluses & pens

Benevo UltraPen battery

2 × 1.55V silver oxide button cell

Based on
Benevo documentation
Last checked
9 October 2026
Size
7.9 × 3.6 mm
Voltage
1.55 V
Rechargeable
Not supported

How to replace it

How to openOpen the pen battery compartment as shown in the Quick Start. Insert two SR41 cells with (+) facing up, then close the compartment securely.
OrientationPositive (+) poles facing up as shown in the QSG diagram
AccessTool-free
NotesReplace both cells together. The base/charging unit is separate (USB) — these SR41 cells power the pen tip/sensor assembly.

Important

  • Benevo QSG names SR41 silver oxide only — do not substitute LR41 / AG3 alkaline unless a later revision says otherwise.
  • Button cells are a choking hazard — keep new and used cells away from children.

Sources

Need a SR41?

Benevo UltraPen uses 2 × SR41.

Buy links go to Amazon (Associates where tagged) or other affiliate programmes when available. They never change the battery answer.

Helpful for this device

Optional tools for opening, testing or charging — separate from the battery answer.

Amazon links may earn us a commission. They do not change the battery answer.

  • Digital multimeter

    Measure open-circuit voltage and general electronics checks

    Voltage alone does not establish usable capacity, especially for rechargeables.

Buy links are optional and separate from the battery answer.

New battery but still not working?

A fresh 2 × SR41 should restore Benevo UltraPen if the battery was the problem. Work through the checks below before replacing the device.

  1. Check orientation

    Confirm the cell is seated correctly: Positive (+) poles facing up as shown in the QSG diagram

  2. Check the battery type

    This device needs 2 × SR41 (silver_oxide). Rechargeable cells are not supported for this device. Same size does not always mean the same battery.

  3. Check known model-specific issues

    Benevo QSG names SR41 silver oxide only — do not substitute LR41 / AG3 alkaline unless a later revision says otherwise. Button cells are a choking hazard — keep new and used cells away from children.

  4. Confirm the battery itself

    For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.

  5. Still not responding?

    If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.

These checks follow this device’s orientation, battery type, and important notes from the maker.

Other devices using SR41

See all →

Similar devices