Seiko · Watches
Seiko Cal. 7N22 battery
1 × 1.55V silver oxide button cell
How to replace it
| Notes | Case-back service typically required; water resistance should be retested after opening. Prefer genuine Seiko cells when available. |
|---|
Important
- Confirm the calibre number stamped on the caseback — Seiko reuses model families across calibers.
- Seiko Kinetic / solar / secondary-cell calibers are excluded from this disposable CR/SR publish set.
Sources
Helpful for this device
Optional tools for opening, testing or charging — separate from the battery answer.
- Fluke 101 Digital Multimeter
Accurate open-circuit voltage and basic electrical checks
- Klein Tools MM400 Multimeter
General DC voltage checks including battery terminals
- Digital multimeter
Measure open-circuit voltage and general electronics checks
New battery but still not working?
A fresh 1 × SR920W should restore Seiko Cal. 7N22 if the battery was the problem. Work through the checks below before replacing the device.
- Check the battery type
This device needs 1 × SR920W (silver_oxide). Same size does not always mean the same battery.
- Check known model-specific issues
Confirm the calibre number stamped on the caseback — Seiko reuses model families across calibers. Seiko Kinetic / solar / secondary-cell calibers are excluded from this disposable CR/SR publish set.
- Confirm the battery itself
For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.
- Still not responding?
If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.