Casio · Watches
Casio G-Shock DW-5600 battery
1 × 3V lithium coin cell
How to replace it
| Notes | Watchmaker/case-back service typically required; water resistance must be retested after open |
|---|
Important
- Module 3489 uses CR1616 — verify module before ordering; water resistance risk after DIY
- DW-5600 family spans multiple modules; some variants use CR1616. Confirm module on caseback before ordering.
Sources
Helpful for this device
Optional tools for opening, testing or charging — separate from the battery answer.
- Fluke 101 Digital Multimeter
Accurate open-circuit voltage and basic electrical checks
- Klein Tools MM400 Multimeter
General DC voltage checks including battery terminals
- Digital multimeter
Measure open-circuit voltage and general electronics checks
New battery but still not working?
A fresh 1 × CR2016 should restore Casio G-Shock DW-5600 if the battery was the problem. Work through the checks below before replacing the device.
- Check the battery type
This device needs 1 × CR2016 (lithium). Rechargeable cells are not supported for this device. Same size does not always mean the same battery.
- Check known model-specific issues
Module 3489 uses CR1616 — verify module before ordering; water resistance risk after DIY DW-5600 family spans multiple modules; some variants use CR1616. Confirm module on caseback before ordering.
- Confirm the battery itself
For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.
- Still not responding?
If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.