Bushnell · Golf rangefinders
Bushnell Pro X2 battery
1 × 3V lithium cell
How to replace it
| How to open | Open battery compartment cover (lift tab / rotate as fitted on unit) |
|---|---|
| Orientation | Negative (flat) end first; positive end facing out toward battery cover |
| Water resistance | Manufacturer states waterproof — reseat battery door fully after replacement |
| Notes | After installing a new CR2, press and hold the Fire button for 10 seconds. Carry 1–2 spare CR2 cells. |
| Access | Tool-free |
Important
- Bushnell recommends a high-quality CR2 (e.g. Panasonic, Duracell, or Energizer) fresh from the package.
Sources
Helpful for this device
Optional tools for opening, testing or charging — separate from the battery answer.
- Fluke 101 Digital Multimeter
Accurate open-circuit voltage and basic electrical checks
- Klein Tools MM400 Multimeter
General DC voltage checks including battery terminals
- Digital multimeter
Measure open-circuit voltage and general electronics checks
New battery but still not working?
A fresh 1 × CR2 should restore Bushnell Pro X2 if the battery was the problem. Work through the checks below before replacing the device.
- Check orientation
Confirm the cell is seated correctly: Negative (flat) end first; positive end facing out toward battery cover
- Check the battery type
This device needs 1 × CR2 (lithium). Rechargeable cells are not supported for this device. Same size does not always mean the same battery.
- Check known model-specific issues
Bushnell recommends a high-quality CR2 (e.g. Panasonic, Duracell, or Energizer) fresh from the package.
- Confirm the battery itself
For most coin cells, fitting a known-good fresh cell of the correct code is simpler than capacity testing.
- Still not responding?
If a correct, fresh battery installed properly does not restore the device, the fault may be elsewhere — the device may need service or replacement.
Current model
If this model is finished, the Manufacturer successor model is Bushnell Pro XE.